Abstract: It is shown by the result of digital magnetotelluric soundings in the Tangshan seismic area and its surrounding regions that the crust under the surface conductive sediments is divided into two layers, i. e., the resistive upper crust and the conductive lower crust. The upper crust wherein the Tangshan main shock and most of the aftershocks occurred is a convex lens- like body which is cut by faults at the east, south and west sides. The focus of the main shock was located at the position of the downward depression of the resistive upper crust while the spatial variation of Curie point isothermal surface and the deepest limit of the depths of aftershocks coincide with the downward depression of the bottom of the resistive upper crust. Thus, the Tangshan main shock and most of its aftershocks were related closely to the resistive upper crust from the view points of either vertical layering or lateral variations. And there were only a very few aftershocks in the conductive lower crust. The mechanical property of the rocks transforms from being brittle in the upper crust into ductile in the lower crust mainly due to the combination of different factors, e.g., increase of confining pressure, change in minerals, rise in temperature as well as existence of pore- pressure. A small amount of water and a rise in temperature may lead to noticeable falling of the electric resistivity within the rock while a change in the static pressure and mineral content within the rock causes very little change in the electric resistivity. Thus it is deduced that a resistive upper crust and a more conductive lower crust from the view points of either vertical or lateral variations are related genetically to the brittle and ductile properties respectively. Hence it is possible that there is a relationship between the electric structure of the crust and zones of potential seismic hazard.